Convolution reverb: HybridReverb2 by ICA

HybridReverb2 è un convolution reverb, anche per Linux, sviluppato da ICA.

HybridReverb2 is a convolution-based reverberation effect which combines the superior sound quality of a convolution reverb with the tuning capability of a feedback delay network.

The sound quality of a convolution reverb depends on the quality of the used room impulse responses. HybridReverb2 comes with a set of room impulse responses which were synthesized with tinyAVE, an auralization software which was developed at the Institute of Communication Acoustics, Ruhr-Universit??_?_?t Bochum (Bor?_???? and Martin, 2009; Bor?_????, 2009a). These room impulse responses are designed for a speaker setup with two front and two rear speakers (Bor?_????, 2009b). For a full surround sound effect, you will need two plugins, one plugin which uses a “front” preset for the front channels and a second plugin which uses the corresponding “rear” preset for the rear channels.

free and open source plugin (GPL)
high quality room impulse responses (PCM, 48kHz, 24bit)
rear channel impulse responses for a natural spatial envelopment
low latency (down to 64 samples)
low CPU load
individual performance optimizer
intuitive and clearly arranged user interface
quick selection of presets via categories
tuning of room impulse responses:initial gap / length / pre-delayo, dry / wet / master gain, envelope (with increasing resolution for fine tuning the early reflections), timbre (equalizer with 1/3 octave resolution)
editor for the preset database
user specified impulse responses can also be used

(2 votes, average: 4,00 out of 5)

Loading...